[Feb-2024] 300-430 exam torrent Cisco study guide
Use Valid New 300-430 Test Notes & 300-430 Valid Exam Guide
Cisco 300-430 exam is an essential certification for individuals looking to enhance their skills in the wireless network domain. 300-430 exam covers a wide range of topics related to wireless network design, deployment, security, and troubleshooting. Candidates can prepare for the exam by enrolling in training courses or using practice exams to assess their knowledge. Passing the exam and obtaining the certification can open up opportunities for career advancement in the wireless network domain.
NEW QUESTION # 58
A Cisco WLC has been added to the network and Cisco ISE as a network device, but authentication is failing.
Which configuration within the network device configuration should be verified?
- A. SNMP RO community
- B. device ID
- C. device interface credentials
- D. shared secret
Answer: D
NEW QUESTION # 59
Which three properties are used for client profiling of wireless clients? (Choose three.)
- A. DHCP
- B. HTTP user agent
- C. OS version
- D. IP address
- E. MAC OUI
- F. hostname
Answer: A,B,E
Explanation:
NEW QUESTION # 60
An engineer is implementing profiling for BYOD devices using Cisco ISE. When using a distributed model, which persona must the engineer configure with the profiling service?
- A. Policy Services Node
- B. Primary Admin Node
- C. Device Admin Node
- D. Monitor Node
Answer: A
NEW QUESTION # 61
A network engineer observes a spike in controller CPU overhead and overall network utilization after multicast is enabled on a controller with 500 APs. Which feature corrects the issue?
- A. multicast AP multicast mode
- B. controller IGMP snooping
- C. unicast AP multicast mode
- D. broadcast forwarding
Answer: A
NEW QUESTION # 62
A shopping center uses AireOS controllers with Cisco Wave 2 APs. A separate WLAN named Guest-012345678-WLAN is used for guest wireless clients. Management need's location analytics to determine popular areas. CMX must track only associated clients. What must be selected on the CMX server settings?
- A. Enable Location MAC Filtering
- B. Exclude probing clients
- C. Duty Cycle Cutoff
- D. Enable Locally Administered MAC Filtering
Answer: B
NEW QUESTION # 63
Which CLI command do you use to shut down the 2.4 GHz radio of the Floor1_AP1 AP on a Cisco 3850 Switch?
- A. ap name Floor1_AP1 dot11 shutdown 24ghz
- B. ap name Floor1_AP1 shutdown dot11 24ghz
- C. ap name Floor1_AP1 dot11 5ghz shutdown
- D. ap name Floor1 AP1 dot11 24ghz shutdown
Answer: D
NEW QUESTION # 64
A corporation is spread across different countries and uses MPLS to connect the offices. The senior management wants to utilize the wireless network for all the employees. To ensure strong connectivity and minimize delays, an engineer needs to control the amount of traffic that is traversing between the APs and the central WLC. Which configuration should be used to accomplish this goal?
- A. FlexConned mode with central switching enabled
- B. FlexConnect mode with local authentication
- C. FlexConnect mode with OfficeExtend enabled
- D. FlexConnect mode with central authentication
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/wireless/controller/72/configuration/guide/cg/cg_flexconnect.html#wp12
NEW QUESTION # 65
An engineer must deploy FlexConnect APs to a site that typically has 300 ms latency to the WLC. Which typical operating mode must the engineer plan on for normal operations?
- A. local authentication, local switching
- B. central authentication, local switching
- C. connected mode
- D. central authentication, central switching
Answer: A
Explanation:
Explanation/Reference:
References: http://www.cisco.com/c/en/us/td/docs/wireless/controller/7-2/configuration/guide/cg/ cg_flexconnect.html
NEW QUESTION # 66
Refer to the exhibit.
An administrator notices slower location updates from the controller to Cisco CMX. Which command must be configured to get an update every 5 seconds for rogues?
- A. config location notification interval rssi rogues 5
- B. config subscription notification interval rssi rogues 5
- C. config cmx notification interval rssi rogues 5
- D. config nmsp notification interval rssi rogues 5
Answer: D
NEW QUESTION # 67
Refer to the exhibit.
An engineer is troubleshooting a client connectivity issue. The client is in the RUN state, and no traffic is passed after authenticating by using Cisco ISE. Which action resolves the problem?
- A. Apply a lower WMM QoS.
- B. Disable the ACL that prevents traffic from being allowed.
- C. Enable rate-limiting to the client.
- D. Configure a different client VLAN after authentication.
Answer: D
NEW QUESTION # 68
The security policy mandates that only controller web management traffic is allowed from the IT subnet. In testing, an engineer is trying to connect to a WLAN with Web Authentication for guest users, but the page is timing out on the wireless client browser. What is the cause of this issue?
- A. The DNS server that is configured on the controller is incorrect
- B. The implemented CPU ACL on the controller is blocking HTTP/HTTPS traffic from the guest clients.
- C. Web Authentication Redirect is not supported with CPUACLS. QUE
- D. Web Authentication Redirect is supported only with Internet Explorer, and the client is using Google Chrome.
Answer: B
NEW QUESTION # 69
An engineer configures the wireless LAN controller to perform 802.1x user authentication. Which configuration must be enabled to ensure that client devices can connect to the wireless, even when WLC cannot communicate with the RADIUS?
- A. local EAP
- B. Cisco Centralized Key Management
- C. pre-authentication
- D. authentication caching
Answer: A
Explanation:
NEW QUESTION # 70
During the EAP process and specifically related to the client authentication session, which encrypted key is sent from the RADIUS server to the access point?
- A. session key
- B. shared-secret key
- C. encryption key
- D. WPA key
Answer: A
NEW QUESTION # 71
What is the difference between PIM sparse mode and PIM dense mode?
- A. Sparse mode floods. Dense mode uses distribution trees.
- B. Sparse mode uses distribution trees. Dense mode floods.
- C. Sparse mode supports multiswitch networks. Dense mode supports only one switch.
- D. Sparse mode supports only one switch. Dense mode supports multiswitch networks.
Answer: B
Explanation:
Explanation
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-16/imc-pim-xe-16-book/imc-te In Sparse mode packets branches distribution growth as new nodes join the multicast group.
https://community.calix.com/s/article/Dense-Mode-Multicast-vs-Sparse-Mode-Multicast-1
NEW QUESTION # 72
Refer to the exhibit.
An engineer is creating an ACL to restrict some traffic to the WLC CPU. Which selection must be made from the direction drop-down list?
- A. Packet direction has no significance; it is always Any.
- B. It must be Outbound because it is traffic that is generated from the WL
- C. To have the complete list of options, the CPU ACL must be created only by the CLI.
- D. It must be Inbound because traffic goes to the WLC.
Answer: D
Explanation:
NEW QUESTION # 73
......
300-430 Exam questions and answers: https://passleader.examtorrent.com/300-430-prep4sure-dumps.html
